收藏本站
Conformal Coated Guide
www.vishay.com
GUIDE TO APPLICATION
Vishay Sprague
P
V R MS = Z ------------
1.
2.
AC Ripple Current: The maximum allowable ripple
current shall be determined from the formula:
I R MS =
------------
R ESR
where,
P=
Power dissipation in W at + 25 °C as given in
the tables in the product datasheets (Power
Dissipation).
R ESR = The capacitor equivalent series resistance at
the specified frequency
AC Ripple Voltage: The maximum allowable ripple
voltage shall be determined from the formula:
V RMS = I R MS x Z
or, from the formula:
P
R ESR
where,
P = Power dissipation in W at + 25 °C as given in
the tables in the product datasheets (Power
Dissipation).
R ESR = The capacitor equivalent series resistance at
the specified frequency
5.
6.
6.1
7.
Power Dissipation: Power dissipation will be
affected by the heat sinking capability of the
mounting surface. Non-sinusoidal ripple current may
produce heating effects which differ from those
shown. It is important that the equivalent I RMS value
be established when calculating permissible
operating levels. (Power dissipation calculated using
derating factor (see paragraph 4)).
Attachment:
Soldering: Capacitors can be attached by
conventional soldering techniques, convection,
infrared reflow, wave soldering and hot plate
methods. The soldering profile chart shows typical
recommended time/temperature conditions for
soldering. Preheating is recommended to reduce
thermal stress. The recommended maximum preheat
rate is 2 °C/s. Attachment with a soldering iron is not
recommended due to the difficulty of controlling
temperature and time at temperature. The soldering
iron must never come in contact with the capacitor.
Recommended Mounting Pad Geometries: The
nib must have sufficient clearance to avoid electrical
contact with other components. The width
dimension indicated is the same as the maximum
width of the capacitor. This is to minimize lateral
movement.
Z=
The capacitor impedance at the specified
frequency
8.
Cleaning (Flux Removal) After Soldering:
T ANTAMOUNT ? capacitors are compatible with all
commonly used solvents such as TES, TMS, Prelete,
2.1
2.2
3.
4.
The sum of the peak AC voltage plus the applied DC
voltage shall not exceed the DC voltage rating of the
capacitor.
The sum of the negative peak AC voltage plus the
applied DC voltage shall not allow a voltage reversal
exceeding 10 % of the DC working voltage at
+ 25 °C.
Reverse Voltage: Solid tantalum capacitors are not
intended for use with reverse voltage applied.
However, they have been shown to be capable of
withstanding momentary reverse voltage peaks of up
to 10 % of the DC rating at 25 °C and 5 % of the DC
rating at + 85 °C.
Temperature Derating: If these capacitors are to be
operated at temperatures above + 25 °C, the
permissible RMS ripple current or voltage shall be
calculated using the derating factors as shown:
TEMPERATURE
DERATING FACTOR
+ 25 °C
1.0
+ 85 °C
0.9
+ 125 °C
0.4
Chlorethane, Terpene and aqueous cleaning media.
However, CFC/ODS products are not used in the
production of these devices and are not
recommended. Solvents containing methylene
chloride or other epoxy solvents should be avoided
since these will attack the epoxy encapsulation
material.
Revision: 03-Apr-14
11
Document Number: 40150
For technical questions, contact: tantalum@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
CWR15FK225KCLC CAP TANT 2.2UF 10% 10V 0603
CWR29KC336KCXC CAP TANT 33UF 25V 10% 2721
CWSB21AA2H SWITCH ROCKER DPST 6A 250V
CWSB21DADF SWITCH ROCKER DPST 9A 125V
CWSC21JDADS SWITCH ROCKER DPST 9A 125V
CX2016DB27000D0GEJZ1 CRYSTAL 27.000MHZ 8PF SMD
CX2016DB40000D0FLJZ1 CRYSTAL 40.000MHZ 8PF SMD
CX2520DB20000D0FLJZ1 CRYSTAL 20.000MHZ 8PF SMD
相关代理商/技术参数
CWR06NC105MR/TR 制造商:Vishay Intertechnologies 功能描述:Cap Tant Solid 1uF 50V E CASE 20% (5.08 X 2.54 X 1.27mm) SMD (0.01%FR) 6 Ohm 125C T/R 制造商:Vishay Sprague 功能描述:CAP 1UF 50VDC 20% 5.08 X 2.54 X 1.27MM SMD 0.01% - Tape and Reel
CWR06NC105MRA 制造商:Vishay Sprague 功能描述:CAP 1UF 50VDC 20% 5.08 X 2.54 X 1.27MM SMD 0.01% - Bulk
CWR06NC105MRB 制造商:Vishay Sprague 功能描述:CAP 1UF 50VDC 20% 5.08 X 2.54 X 1.27MM SMD 0.01% - Bulk
CWR06NC105MRC 制造商:Vishay Sprague 功能描述:CAP 1UF 50VDC 20% 5.08 X 2.54 X 1.27MM SMD 0.01% - Bulk
CWR06NC154MC 制造商:Vishay Sprague 功能描述:CAP 0.15UF 50VDC 20% 2.54 X 1.27 X 1.27MM SMD 0.01% - Bulk
CWR06NC154MM 制造商:Vishay Sprague 功能描述:CAP 0.15UF 50VDC 20% 2.54 X 1.27 X 1.27MM SMD 1% - Bulk
CWR06NC154MP 制造商:Vishay Sprague 功能描述:CAP 0.15UF 50VDC 20% 2.54 X 1.27 X 1.27MM SMD 0.1% - Bulk
CWR06NC155JB/TR 制造商:Vishay Sprague 功能描述:CAP 1.5UF 50VDC 5% 5.59 X 3.43 X 1.78MM SMD 0.1% - Tape and Reel